Review: Audio-Technica ATH-SR5BT


Audiophiles typically shun wireless headphones because of poor sound quality. However, Bluetooth audio has improved tremendously over the years. There are now plenty of wireless headphones that can please the music enthusiast, with Hi-Res Audio support being more and more prevalent.

For the unfamiliar, the Hi-Res Audio label you see on the box means a headphone must meet certain criteria to be able to play higher than CD-quality music. This means a headphone must be able to decode and playback music that’s 24 bit/96 kHz and above. (That’s actually a cut above CDs, which are recorded at 16 bit/44.1 kHz.)

On paper, Audio-Technica ATH-SR5BT is an impressive wireless headphone with a frequency response of 5-40,000 Hz, meaning that pretty much no note goes unheard. It also lasts a stunning 38 hours on a charge so you can go days, if not weeks, without charging them.

After spending some time with the ATH-SR5BT, we can say that the headphones live up to its lofty claims. They offer balanced sound, great design and revealed details in our music we didn’t think was possible for a headphone that costs $199 (£149, AU$369).


The design of the Audio-Technica ATH-SR5BT is understated with an all black finish and some silver accents, though there’s a white-on-silver version as well if you’re into the clean sci-fi look. The headphones feature metal earcups with soft leather earpads and headband that are the definition of comfortable. That said, they’re an over-ear design but they do a good job of passively blocking outside noise.

On the head, the ATH-SR5BT are extremely comfortable, mostly due to their light weight. The earpads are made of soft memory foam and feel excellent, even after long listening sessions. There’s very little clamping force, which is great for long listening sessions but they can be a little loose for users who want to exercise with them.

Audio Technica ATH SR5BT

All controls are located on the back of each earcup. The right earcup has a toggle switch for power while the left earcup features playback controls, the microUSB charging port and the 3.5mm jack for using in wired mode.

Inside the earcups are 45mm drivers that are capable of an incredible frequency response of 5-40,000 Hz. The headphones have a 45 ohm impedance, which means you won’t need an amp to properly drive them.

Audio Technica ATH SR5BT

Included in the box are a microUSB charging cable, a 3.9 ft (1.2 m) wired headphone cable and a soft carrying case. The wired headphone cable comes with a microphone and a single-button remote for controlling playback and answering calls.


Pairing the ATH-SR5BT with my OnePlus 3 couldn’t have been easier with the inclusion of NFC – one tap on the back of your NFC-enabled phone to the left headband quickly pairs the headphone with your device.

While Audio-Technica brags that the headphone can remember up to 8 devices, you’ll have to disconnect and connect to devices in your Bluetooth settings as the headphones can’t connect to multiple device simultaneously. There are headphones do support multiple devices at once, like the Plantronics Backbeat Pro, and it’d be great to see Audio-Technica include this feature in the future, as it’s a pain to hunt around in the settings to switch devices.

Audio Technica ATH SR5BT

There’s support for aptX and AAC codecs, which means wireless audio via Bluetooth 4.1 will sound great with either Android or iPhones. Note that using the headphones in Bluetooth mode will only give you frequency response of 20-20,000 Hz while using them in wired mode will get you the full 5-40,000 Hz required for Hi-Res Audio.

Controlling playback with the earcup controls is relatively simple, but will take some getting used to since it’s both a toggle and button. Toggling up and down will change the volume, but you can hold up to skip forward and hold down to skip back. Pressing on the toggle will play/pause music or answer/reject a call.

Speaking of phone calls, friends and family reported clear sounding audio on their end during our conversations, and noted that it sounded much better than using the mic on my OnePlus 3.

Audio Technica ATH SR5BT


Enough about features. How do the ATH-SR5BT sound? In short, phenomenal. Sound is well balanced across the entire frequency range, though there is a slight treble and mid-bass boost. This means highs can sound a little bit fatiguing for those who are treble sensitive. I like my treble a little hot and found them to be right on the edge of being too energetic.

All of that high frequency energy means the ATH-SR5BT have great resolution for well recorded music. You’ll hear musicians breathe or tap their feet, something other wireless headphones can’t reproduce. Soundstage is well rendered – but could stand to be a bit wider.

Audio Technica ATH SR5BT

Bass is taught with good impact but low-end enthusiasts will likely want headphones that can dig deeper. Bassheads should check out the Marshall Major II Bluetooth to satisfy the urge for EDM and rap, but expect muddier bass and far less resolution.

While most people will use the ATH-SR5BT in wireless mode most of the time, it’s worth plugging them in just to experience what Hi-Res Audio is capable of. I plugged in the headphones with the included cable and was blown away by how much better everything sounded: Bass had more impact, especially when used with an amp like my Fiio E18 and WooAudio 3. I was addicted to wired mode for days.

Audio Technica ATH SR5BT

Audio-Technica’s claims for 38 hours of playback are spot on. I struggled to drain the battery within the week I spent with the headphone. They have some serious stamina. They take quite a bit of time (around 5 hours) to charge to full from dead, however, so you’ll want to leave them on the charger overnight.

We liked

The Audio-Technica ATH-SR5BT feature some of the best wired and wireless sound quality for a headphone under $200 (£150). It plays well with all music genres and offer a near-flat response curve. They’re extremely comfortable for long listening sessions and are well built. Battery life is equally impressive with nearly 40 hours of playback from a charge.

We disliked

While the ATH-SR5BT do a good job of isolating outside noise, it would have been nice to have active noise cancelling, though it’s an understandable omission at this price point. Some listeners may find the headphones a little bright and fatiguing. Lastly, it would have been nice if the headphones could pair to multiple devices simultaneously.

Final verdict

The Audio-Technica ATH-SR5BT strike an amazing balance between portability and serious listening. Sound over Bluetooth is great for commuting or when you’re less interested in absolute fidelity. Then, once you’ve safely arrived back home or find yourself in a quiet environment, it’s super easy to switch to wired mode to get Hi-Res Audio sound.

At their $199 (£149, AU$369) price point, the ATH-SR5BT offer great value for audiophiles who want the convenience of going wireless. Sure, they lack the features of more expensive wireless headphones like active noise cancelling and multi-device pairing, but these are tradeoffs worth making for phenomenal sound.


Source link

Leave a Reply