Slovenian start-up aims to revolutionise test and measurement

[ad_1]

The MonoDAQ E-ACC accelerometer amplifier is claimed to save costs and increase the accuracy of acceleration and vibration measurement by enabling the module to be placed near the sensor, eliminating the need for long analogue cabling.

Monodaq E-ACC is a compact device in an  aluminium housing consisting of analogue front end with 18 kHz alias-free bandwidth, 24 bit ADC converter with up to 40 kS/s sample rate and EtherCAT interface.

The EtherCAT protocol is a key factor in enabling large distances between devices – up to 50 m node-to-node. Devices are simply daisy-chained with a single network cable that carries signal and power. Synchronization below 1 µs is ensured along a virtually-unlimited chain of MonoDAQ E-ACC devices.

Each MonoDAQ-E device has a fully isolated front end with high dynamic performance as well as TEDS support for sensor auto-recognition.

MonoDAQ E-ACC devices come bundled with the powerful DEWESoft software which enables engineers without specialist electronics knowledge to be able to measure their phenomena of interest – usually acceleration, force, pressure, temperature, etc.

Analogue, digital, GPS and video signals can be measured in the same environment and synchronized without any customization – no programming is needed to make a high-fidelity measurement.

[ad_2]

Source link